Skip to main content

Vantage Plumbing and Heating

Back Boiler Replacement: What Is Involved and Your Options

Hertfordshire, Bedfordshire & Cambridgeshire

Fully Stocked Vans12 Month Labour GuaranteeGas Safe Registered 956889

Replacing a back boiler means removing the old boiler from behind the fireplace, making the chimney and gas fire safe, and fitting a new condensing boiler somewhere else in the house, usually as a combi or system boiler. Back boilers are not illegal to keep using if they are safe, but new gas boilers have had to be condensing boilers since 2005, and a traditional back boiler is not, so a like-for-like swap is not normally possible.

In short

  • A back boiler sits in the fireplace behind a gas fire and uses the chimney as its flue. The Baxi Bermuda is the best known example.
  • You can keep using a back boiler while it is safe and serviced, but when it fails it is replaced with a modern condensing boiler, not another back boiler.
  • The new boiler usually goes in the kitchen, a utility room, the airing cupboard or the loft, wherever a flue and condensate drain can be run.
  • Many households switch to a combi at the same time and remove the hot water cylinder and loft tanks. It is not always the right choice.
  • The fireplace can be blocked up and vented, fitted with a new fire, or opened up again.
  • The job takes longer than a straight boiler swap because of the pipework, the chimney and often a system conversion.
Ideal boiler installed by Vantage in a fitted cupboard, with copper pipework and a magnetic system filter
One of our boiler installations: an Ideal combi in a fitted cupboard with a magnetic system filter.

What a back boiler is

A back boiler is a boiler built to fit in the fireplace opening, behind a gas fire. The two usually share the chimney as a flue, and the fire often has its own controls on the front. Back boilers were popular for decades because they took up no wall or cupboard space, and many homes in Hertfordshire still have one running an older open vent system: a hot water cylinder in the airing cupboard, fed by a cold water tank and a smaller feed and expansion tank in the loft.

Traditional back boilers are not condensing boilers. They send much of their heat up the chimney, where a modern condensing boiler recovers extra heat from the flue gases. Energy Saving Trust and boiler manufacturers both note that gas boilers installed since 2005 have had to be condensing, which is why back boilers are now replaced rather than renewed.

Are back boilers illegal?

No. There is no law that says you must remove a working back boiler. What matters is that it is safe:

  • It should be serviced every year by a Gas Safe registered engineer, including the gas fire in front of it.
  • The chimney it uses as a flue must be clear and in good condition, and the room must have the ventilation the appliance needs.
  • If an engineer finds it unsafe, they will follow the gas industry’s unsafe situations procedure and may disconnect it, with your permission, or advise you not to use it.

The practical problem is not the law. It is age. Most back boilers still in use are many years old, spares for some models are harder to find, and a breakdown in winter can leave you without heating or hot water while a replacement is planned. Replacing one on your own timetable is far less stressful than doing it after it fails. Our boiler installation page explains how we plan a replacement.

Signs it is time to replace your back boiler

  1. It keeps breaking down, or the same part keeps failing.
  2. Parts are hard to get, so repairs take longer and cost more.
  3. The gas fire has problems, such as a pilot light that keeps going out or sooting on the glass or fire front.
  4. Radiators take a long time to heat and hot water runs out quickly.
  5. An engineer has advised it is at risk during a service or safety check.
  6. You want the space back, or want to reopen or change the fireplace.

If you are unsure whether to repair or replace, our repair or replace guide sets out how we decide.

Your replacement options

The right new boiler depends on how many bathrooms you have, how many people use hot water at once and your mains water pressure and flow.

OptionHow it worksSuitsWhat changes
Combi boilerHeats hot water on demand from the mains, no cylinder or tanksHomes with one bathroom and good mains flowCylinder and loft tanks removed, airing cupboard freed up
System boiler with unvented cylinderStores mains pressure hot water in a cylinderHomes with two or more bathrooms, or several people showering at onceLoft tanks removed, new cylinder in the airing cupboard
Regular (heat only) boilerKeeps the existing cylinder and loft tanksHomes with low mains pressure, or where you want to keep the current layoutLeast pipework change, still needs a new flue and boiler position

A combi is the most common choice, but it is not always right. If your mains flow is weak or two showers run at the same time, a system boiler with an unvented cylinder may serve you better. Our guide to the best combi boilers covers the models we fit most often, and we are Ideal Max accredited and Vaillant myREWARDS installers, which means manufacturer guarantees of up to 12 years on selected Ideal boilers and up to 10 years on selected Vaillant boilers.

Where the new boiler can go

Because a condensing boiler needs its own flue to outside and a drain for its condensate, it is normally fitted on or near an outside wall. Common positions are:

  • The kitchen or utility room, often in a wall cupboard.
  • The airing cupboard, once the old cylinder is removed on a combi conversion.
  • The loft, if it is boarded, lit and has a safe fixed ladder for servicing.
  • A garage, with frost protection for the pipework.

The survey decides this, based on where the flue can terminate safely, how the gas pipe will reach it and how long the hot water pipe runs to the taps will be.

The back boiler replacement process, step by step

  1. Survey. We check the boiler, fire, chimney, gas meter and pipe size, mains flow, the hot water system and the best new boiler position.
  2. Make safe and remove. The gas fire and back boiler are disconnected and removed by a Gas Safe engineer. Old fireplaces and surrounds can contain asbestos in older homes, so anything suspect is identified before it is disturbed.
  3. Deal with the chimney. If the fireplace will not be used, the chimney is capped at the top and vented so it stays dry, and the opening is closed with a vent. If you want a new gas fire, the chimney and flue must suit that fire.
  4. Convert the system if needed. For a combi or system boiler, the loft tanks and old cylinder come out and the pipework is altered to run as a sealed system.
  5. Clean the system. Old systems carry sludge. A power flush or chemical clean protects the new boiler, and a magnetic system filter is fitted.
  6. Fit the boiler, flue and controls, including a new gas supply route and condensate pipe.
  7. Commission and register. The boiler is set up and tested, the installation is registered with the manufacturer for the guarantee, and as a Gas Safe registered business we notify building control so you receive a Building Regulations compliance certificate.

Safety points

  • Do not remove a gas fire or back boiler yourself. Disconnecting any gas appliance is Gas Safe work only.
  • Do not use an open fire in a chimney that has served a gas back boiler until it has been swept and checked.
  • If you smell gas, call the National Gas Emergency Service on 0800 111 999, open windows, do not use electrical switches, and turn the gas off at the meter if it is safe to do so.

What happens to the fireplace

You have three main choices once the back boiler has gone.

  • Close it up. The opening is blocked and fitted with an air vent, and the chimney is capped and ventilated to prevent damp.
  • Fit a new fire. A new gas or electric fire can go in. A gas fire needs a suitable flue and its own safety checks.
  • Open it up. Some people restore the original fireplace. That needs the chimney swept and inspected before any fire is lit.

How we price it

Installations are quoted as a fixed price after a free survey, so the price you agree is the price you pay. You can get your price online in a couple of minutes with our boiler quote tool, and a back boiler replacement is then confirmed at the survey, because the chimney, pipework and any system conversion vary from house to house. Every new boiler package includes a magnetic system filter, the first year’s service and removal of the old boiler, and our work has a 12 month labour guarantee. Our other rates are published on our prices page.

Frequently asked questions

Can I replace a back boiler with a new back boiler?

In practice, no. New gas boilers have had to be condensing since 2005, and traditional back boilers are not, so the replacement is a modern condensing boiler fitted elsewhere with its own flue.

Can I keep my gas fire when the back boiler is removed?

Sometimes. It depends on the condition and age of the fire and whether it can run safely on its own with the chimney as it is. Many people choose a new fire or close the fireplace at the same time.

Do I need new radiators with a new boiler?

Not usually. Radiators in good condition can stay, although the system should be cleaned, and any radiators that are undersized or blocked with sludge may be worth replacing while the work is being done.

Is a combi boiler always the best replacement?

No. A combi suits most homes with one bathroom and good mains water flow. Larger households, or homes with weak mains pressure, often do better with a system or regular boiler and a hot water cylinder.

Is there a grant for back boiler replacement?

The Boiler Upgrade Scheme only helps if you switch to a heat pump, or in some rural homes a biomass boiler. Help towards a new gas boiler is limited and depends on income and benefits, so check gov.uk before relying on it.

Back boiler replacement in Hertfordshire, Bedfordshire and Cambridgeshire

We replace back boilers across the area, from survey and chimney to the new boiler and controls. See our boiler installation page or call 01462 506374. We are Gas Safe registered (956889) and rated 4.9 on Google.

What our customers say

Speak to a local engineer

Vantage Plumbing and Heating covers Hertfordshire, Bedfordshire and the surrounding areas. Call and talk to an engineer, or send us the details and we will come back to you with a price.

Gas Safe registered, number 956889. Emergency line answered 24/7.

Trusted & Accredited Professionals
Checkatrade approved trader
City and Guilds qualified engineers
BPEC certified engineers
Gas Safe registered engineers
Elite CHAS accreditation
London and South East England Prestige Awards 2022 winner
Veriforce CHAS accredited contractor

Rather have an engineer look at it?

Call the office, message us on WhatsApp or ask for a callback. We cover Hertfordshire, Bedfordshire and the surrounding areas.

Why choose Vantage

Rated 4.9 on Google from more than 700 reviews across Google, Checkatrade and Trustatrader. Qualified, accredited engineers, a fixed price before any work begins and a labour guarantee on every job, from an established local company with an office team you can actually reach. No job too small.

The Vantage Plumbing and Heating fleet of five fully stocked liveried vans

Gas Safe registered

Company registration 956889. Every gas engineer carries their own Gas Safe ID card, and you can ask to see it.

Refcom F-Gas certified

REF1024550. Legally required for air conditioning installation and servicing, and we hold it.

CHAS Elite accredited

Veriforce CHAS assessed for health and safety, which is why commercial clients and landlords use us.

City & Guilds and BPEC qualified

Qualified, insured engineers on every job. No subcontracted strangers.

700+ reviews, 4.9 on Google

Across Google, Checkatrade and Trustatrader. Read them before you book.

Labour guarantee on every job

12 months on repairs, installations and everything else. Two years on a full bathroom refit. If anything we did develops a fault, we come back and put it right.

Fixed price before we start

The price is agreed with you before any work begins. No hidden extras on the invoice.

24/7, answered by a person

The emergency line is answered every day of the year by someone who can send an engineer, not a call centre.

Fully stocked vans

Five vans carrying the parts that fail most often, so most jobs are fixed on the first visit.

An office team behind every job

An established local business with multiple engineers and a dedicated office team to keep you informed.

Vaillant myREWARDS and Ideal Max accredited

Accredited installer status means extended manufacturer warranties on the boilers we fit.

Emergency response within the hour

Our average response to an emergency call is under an hour across Hertfordshire, Bedfordshire and Cambridgeshire.

Quick check

Do we cover your postcode?

We work across Hertfordshire, Bedfordshire, Cambridgeshire, Milton Keynes and North, East and West London, including Hitchin, Stevenage, St Albans, Luton and Cambridge. Pop your postcode in and see straight away.

If we cover you, tell us what you need and how soon, and we will ring you back. Prefer to talk now? Call 01462 506 374, answered by a person 24/7.

✓ Yes, we cover you. Fill in the short form below and we will ring you back.
We might not cover your area yet. Send it anyway: fill in the short form below and we will ring you back and tell you honestly whether we can reach you.
Sorry, we do not work in South London. For anything else, ring 01462 506 374.