Skip to main content

Vantage Plumbing and Heating

Leaking Boiler Condensate Pipe: Is It Dangerous and How Is It Fixed?

Hertfordshire, Bedfordshire & Cambridgeshire

Fully Stocked Vans12 Month Labour GuaranteeGas Safe Registered 956889

A leaking condensate pipe is not usually dangerous in itself: the water is mildly acidic waste from your condensing boiler, so it should be wiped up and kept off skin and pets, but it will not poison you. The leak does need fixing, because condensate damages floors and metal, and a leak often means the pipe is blocked or frozen, which can stop the boiler working altogether.

In short

  • Condensate is slightly acidic water the boiler makes as it runs. A little dripping from the open end of the pipe is normal.
  • Water leaking from a joint, a crack or from under the boiler is not normal.
  • The most common causes are a blockage, a frozen pipe, a loose or badly made joint, or a pipe without enough fall.
  • You can safely check the outside end of the pipe, thaw it with warm water and catch drips.
  • Anything inside the boiler case, including the condensate trap, is a job for a Gas Safe engineer.
Ideal boiler installed by Vantage in a fitted cupboard, with copper pipework and a magnetic system filter
One of our boiler installations: an Ideal combi in a fitted cupboard with a magnetic system filter.

New boiler?

Get an instant estimate for a new boiler

Answer a few questions about your home online and see your estimate straight away, fitted by our own engineers.

Instant boiler estimateOr call 01462 506 374

What the condensate pipe does

Almost every gas boiler fitted in the UK in the last twenty years is a condensing boiler. It squeezes extra heat out of the hot flue gases by cooling them until the water vapour in them condenses. That water, called condensate, collects in a trap inside the boiler and drains away through a plastic pipe, usually white or grey, to a drain, a sink waste, a soil stack or a soakaway.

Because it has passed through the flue gases, condensate is mildly acidic. That is why the pipe is plastic rather than copper, and why it must not drain onto a path or into a metal gutter.

Industry installer guidance sets out how the pipe should be run:

  • at least 19mm internal diameter inside the house, usually 22mm plastic pipe
  • at least 30mm internal diameter where it runs outside or through an unheated space, usually 32mm pipe
  • a steady fall of at least 45mm per metre away from the boiler
  • an external run kept as short as possible, up to a maximum of 3 metres, and insulated

When a pipe does not meet these rules, it is far more likely to leak, block or freeze.

Is a leaking condensate pipe dangerous?

In most cases, no. The honest answer depends on where the water is coming from.

  • Dripping from the open end outside or into a drain. Normal. The boiler is doing its job.
  • Leaking from a joint on the pipe below the boiler. Not dangerous, but it needs repairing. The acidic water will stain and damage flooring, skirting and plaster, and can corrode metal pipes and brackets it drips on.
  • Water coming from inside the boiler case. Switch the boiler off at the controls and call an engineer. The condensate trap inside the boiler holds a water seal that stops flue gases escaping through the drain, and water inside the case can reach electrical parts.

Condensate is mildly acidic, so wear gloves to clean it up, wash it off your skin with water, keep it out of your eyes and do not let pets drink it. If you ever smell gas or fumes, or your carbon monoxide alarm sounds, turn the boiler off, open windows and call the National Gas Emergency Service on 0800 111 999.

If the boiler has stopped or shows a fault code as well as leaking, our boiler repair engineers can find the cause.

Check these first

These checks are safe for a homeowner and do not involve opening the boiler.

  1. Find where the water is coming from. Dry the pipe and the underside of the boiler with a towel, run the heating, and watch where the first drop appears: a joint, a crack, the end of the pipe or inside the boiler.
  2. Make sure it is the condensate pipe. The condensate pipe is plastic. A 15mm copper pipe that runs to the outside wall and drips is usually the pressure relief discharge, which points to a pressure problem instead. Our guide to a boiler that keeps losing pressure explains that one.
  3. Check the outside end. Look for leaves, dirt, insects or ice blocking the open end, and clear it if you can do so safely.
  4. Thaw it if it is frozen. In cold weather, pour warm, not boiling, water along the outside section of pipe, working from the open end back towards the wall. Our frozen condensate pipe guide shows how.
  5. Look at the boiler display. A blocked condensate pipe backs water up into the boiler, and many boilers then lock out with a fault code. Reset the boiler once after clearing the blockage, following your user guide.
  6. Catch the drips. Put a container under the leak and protect the floor until the pipe is repaired.

What not to do

  • Do not remove the boiler casing or try to reach the condensate trap or siphon inside it. Only a Gas Safe registered engineer may work inside a gas boiler.
  • Do not pour boiling water on a frozen pipe. It can crack the plastic.
  • Do not cut or re-route the pipe yourself in a way that removes its fall or leaves it uninsulated outside.
  • Do not ignore water leaking from inside the boiler case, even if the heating still works.
  • Do not keep pressing reset if the boiler locks out again.

Common causes of a leaking condensate pipe

CauseWhat you might noticeCan you fix it yourself?What the engineer does
Blockage in the pipe or at the drainWater backs up and weeps from joints, boiler may gurgle or lock outClear the open end if it is reachableClears or replaces the pipe, checks the trap inside the boiler
Frozen pipeHappens in a cold snap, boiler gurgles then locks outYes, thaw with warm waterRe-runs or insulates the pipe, may increase its size to 32mm outside
Loose or failed jointA steady drip from one joint below the boilerNo, it needs re-makingRe-makes or replaces the joint and fittings
Cracked or split pipeDrip from a length of pipe, often an old or knocked sectionNoReplaces the damaged section
Not enough fallWater sits in the pipe, leaks at low points, more likely to freezeNoRe-runs the pipe with a proper fall
Condensate trap or seal inside the boilerWater on the boiler casing or dripping from underneath the caseNoCleans the trap, replaces seals or the trap, and checks the boiler

Blockages are one of the most common causes. Sludge and debris from the boiler can build up in the trap and the pipe, and outside ends can collect leaves and ice. When water cannot get away, it finds the weakest joint.

What a Gas Safe engineer will check

An engineer works from the boiler outwards:

  • The trap and siphon inside the boiler. Cleaning them, checking the seals and making sure the trap is full, so flue gases cannot pass into the drain.
  • Every joint on the pipe. Loose push-fit joints, solvent-weld joints that were not glued properly, and fittings under strain.
  • The route and fall. Whether the pipe has a steady fall of at least 45mm per metre, with no dips where water can sit.
  • The size and insulation outside. Whether the external run is 32mm pipe, kept short, insulated and finished with a cut end that is less likely to block.
  • Where it drains. Whether it goes to a suitable internal waste or soil stack, which is the preferred option, or to an external drain, gully or soakaway.
  • The boiler itself. Clearing any lockout, checking combustion and making sure no water has got into the electrics.

Cleaning the condensate trap is part of a proper annual boiler service, which is one of the easiest ways to prevent blockages.

Repair or replace?

A leaking condensate pipe is almost always a repair, not a reason to replace the boiler. Re-making a joint, clearing a blockage or re-running the pipe to a better route is usually a short job. It is worth thinking about a new boiler only if the leak is part of a bigger picture, for example an old boiler with a corroded trap, frequent lockouts and other faults. Our guide to a boiler not firing up covers the other reasons a boiler stops working, and how long a boiler lasts explains when replacement makes more sense.

What it costs with Vantage

In normal working hours there is no call-out fee. Gas faults start with a fixed-price Gas Safe diagnostic visit, and if we can fix it on the same visit, part of that diagnostic charge comes off the repair. After the first hour, time is charged in half-hour steps, and parts are quoted before we fit them. Evening, weekend and overnight visits are charged at the out-of-hours rates. Every rate is published on our prices page, so you know what you will pay before we arrive.

Frequently asked questions

Should water drip from my condensate pipe?

Yes, a little. When a condensing boiler is running, condensate drips or trickles from the open end of the pipe into the drain. Water leaking from a joint along the pipe, or from underneath the boiler, is not normal.

Can I use my boiler with a leaking condensate pipe?

If the leak is from an external joint and the boiler is working, you can usually keep using it for a short time with a container underneath. If water is coming from inside the boiler, or the boiler keeps locking out, switch it off and get it checked.

Is boiler condensate harmful to touch?

It is mildly acidic, so it can irritate skin and eyes. Wear gloves to clean it up, rinse any off your skin with water, and keep children and pets away from it.

Why does my condensate pipe keep freezing?

Usually because the outside run is too long, too narrow, not insulated or has too little fall, so water sits in it. Re-running the pipe inside, or fitting 32mm insulated pipe with a proper fall, normally stops it happening again.

Who should repair a condensate pipe leak?

The pipe outside the boiler is plastic waste pipe, but it has to meet the boiler manufacturer’s instructions. Anything at or inside the boiler, including the trap, must be done by a Gas Safe registered engineer.

When to call an engineer

If water is coming from inside the boiler, a joint keeps dripping, or the boiler locks out after you have cleared or thawed the pipe, it is time for an engineer. We cover Hertfordshire, Bedfordshire and Cambridgeshire from our Stevenage base. Book through our boiler repair page or call 01462 506374, answered 24 hours a day, 7 days a week.

What our customers say

Speak to a local engineer

Vantage Plumbing and Heating covers Hertfordshire, Bedfordshire and the surrounding areas. Call and talk to an engineer, or send us the details and we will come back to you with a price.

Gas Safe registered, number 956889. Emergency line answered 24/7.

Trusted & Accredited Professionals
Checkatrade approved trader
City and Guilds qualified engineers
BPEC certified engineers
Gas Safe registered engineers
Elite CHAS accreditation
London and South East England Prestige Awards 2022 winner
Veriforce CHAS accredited contractor

Rather have an engineer look at it?

Call the office, message us on WhatsApp or ask for a callback. We cover Hertfordshire, Bedfordshire and the surrounding areas.

Why choose Vantage

Rated 4.9 on Google from more than 700 reviews across Google, Checkatrade and Trustatrader. Qualified, accredited engineers, a fixed price before any work begins and a labour guarantee on every job, from an established local company with an office team you can actually reach. No job too small.

The Vantage Plumbing and Heating fleet of five fully stocked liveried vans

Gas Safe registered

Company registration 956889. Every gas engineer carries their own Gas Safe ID card, and you can ask to see it.

Refcom F-Gas certified

REF1024550. Legally required for air conditioning installation and servicing, and we hold it.

CHAS Elite accredited

Veriforce CHAS assessed for health and safety, which is why commercial clients and landlords use us.

City & Guilds and BPEC qualified

Qualified, insured engineers on every job. No subcontracted strangers.

700+ reviews, 4.9 on Google

Across Google, Checkatrade and Trustatrader. Read them before you book.

Labour guarantee on every job

12 months on repairs, installations and everything else. Two years on a full bathroom refit. If anything we did develops a fault, we come back and put it right.

Fixed price before we start

The price is agreed with you before any work begins. No hidden extras on the invoice.

24/7, answered by a person

The emergency line is answered every day of the year by someone who can send an engineer, not a call centre.

Fully stocked vans

Five vans carrying the parts that fail most often, so most jobs are fixed on the first visit.

An office team behind every job

An established local business with multiple engineers and a dedicated office team to keep you informed.

Vaillant myREWARDS and Ideal Max accredited

Accredited installer status means extended manufacturer warranties on the boilers we fit.

Emergency response within the hour

Our average response to an emergency call is under an hour across Hertfordshire, Bedfordshire and Cambridgeshire.

Quick check

Do we cover your postcode?

We work across Hertfordshire, Bedfordshire, Cambridgeshire, Milton Keynes and North, East and West London, including Hitchin, Stevenage, St Albans, Luton and Cambridge. Pop your postcode in and see straight away.

If we cover you, tell us what you need and how soon, and we will ring you back. Prefer to talk now? Call 01462 506 374, answered by a person 24/7.

✓ Yes, we cover you. Fill in the short form below and we will ring you back.
We might not cover your area yet. Send it anyway: fill in the short form below and we will ring you back and tell you honestly whether we can reach you.
Sorry, we do not work in South London. For anything else, ring 01462 506 374.