Skip to main content

Vantage Plumbing and Heating

Common Air Conditioning Problems and What Causes Them

Hertfordshire, Bedfordshire & Cambridgeshire

Fully Stocked Vans12 Month Labour GuaranteeGas Safe Registered 956889

The most common air conditioning problems are a unit that runs but does not cool or heat properly, water dripping from the indoor unit, ice on the pipes or coil, bad smells and unusual noises, and most of them come back to dirty filters, a blocked condensate drain, the wrong settings or, less often, a refrigerant leak. You can safely check the settings, the remote and the filters yourself, but anything involving refrigerant or electrical parts needs an F-Gas certified engineer.

  • Dirty filters are the single most common cause of poor cooling, icing and bad smells.
  • Water dripping from the indoor unit usually means a blocked or poorly draining condensate pipe.
  • A unit that blows air but never gets cold, or warm in heat mode, may be low on refrigerant, which means a leak.
  • Some things that look like faults are normal, such as a short delay at start-up, defrost cycles in winter and water from the outdoor unit.
  • Only an F-Gas certified engineer may handle refrigerant. Regular servicing prevents most problems.
Wall mounted air conditioning unit installed by Vantage in a lounge
A wall-mounted air conditioning unit we installed in a lounge.

Problems at a glance

ProblemCommon causesWhat you can checkWhat an engineer does
Not cooling or heating properlyDirty filters, wrong mode or setting, windows open, low refrigerantMode, set temperature, filters, doors and windowsChecks refrigerant pressures, leak tests, cleans coils
Water dripping from indoor unitBlocked condensate drain, dirty filters, failed condensate pump, iced coilClean filters, look for kinks in visible drain pipeClears or re-routes the drain, tests or replaces the pump
Ice on pipes or indoor coilLow airflow from dirty filters, low refrigerant, fan faultSwitch off to thaw, clean filtersFinds the cause, repairs leaks, checks fan
Musty or damp smellMould and bacteria on the filter, coil or drain trayClean the filtersDeep cleans coil and drain tray, treats the unit
Burning or electrical smellElectrical fault or overheating componentSwitch off at the isolator and leave it offElectrical fault finding and repair
Unusual noiseLoose panel, debris, fan or motor wear, compressor faultCheck nothing is touching the outdoor unitDiagnoses the noise, tightens or replaces parts
Will not turn onRemote batteries, isolator or breaker off, fault codeBatteries, isolator, consumer unitReads fault code, tests power supply and boards
Switches on and off oftenOversized unit, sensor fault, dirty coils, refrigerant issueFilters and settingsChecks sensors, charge and sizing

Air conditioner not cooling or heating properly

This is the problem people notice first. Before calling anyone, check:

  1. The mode. Cool mode is usually a snowflake symbol and heat mode a sun. Dry or fan mode will not cool the room properly.
  2. The set temperature. In cool mode it needs to be below the room temperature, and in heat mode above it.
  3. The filters. Daikin’s operation manual for its wall-mounted units recommends cleaning the filters about every two weeks when the unit is in use. A clogged filter cuts airflow and output sharply.
  4. Doors and windows. A unit sized for one room cannot cool or heat a room that is open to the rest of the house or the garden.
  5. The outdoor unit. It needs clear space for air to flow. Remove leaves, covers or anything stacked against it.

If all of that is fine and the unit still blows air that is barely cool or warm, a refrigerant leak is a likely cause. Daikin’s manual says that if the air conditioner is not generating cool or warm air, refrigerant leakage could be the cause. Refrigerant does not get used up, so a system that is low has a leak somewhere. Simply adding more gas without finding the leak is not the answer. An air conditioning repair visit starts with finding where the refrigerant is escaping.

Water leaking from the indoor unit

When an air conditioner cools, it takes moisture out of the air. That water collects in a tray and runs away through a condensate pipe, either by gravity or with a small pump. Water dripping from the indoor unit usually means:

  • A blocked condensate drain, from dust, algae or debris
  • A drain pipe without enough fall, or one that has been kinked or crushed
  • A failed condensate pump, if your system has one
  • Ice melting off the coil, often because of dirty filters

The Daikin manual lists condensation, dirty filters and drain blockage as causes of dripping. Switch the unit off, clean the filters and put a towel under the unit. A drain that is blocked inside the unit or a failed pump needs an engineer.

Ice on the pipes or indoor unit

Frost or ice on the indoor coil or the refrigerant pipes in cooling mode is not normal. It usually means not enough warm air is passing over the coil, because of dirty filters or a fan problem, or that the system is low on refrigerant. Switch the unit off and let it thaw completely before running it again, and clean the filters. If it ices up again, call an engineer.

Frost on the outdoor unit in winter heating mode is a different matter. It is normal, and the system runs a defrost cycle to clear it.

Bad smells

A musty or damp smell when the unit starts is usually mould or bacteria growing on the filters, the coil or in the drain tray, which is common when a unit has not been cleaned for a while. Cleaning the filters helps. A thorough clean of the coil and drain tray is part of a proper air conditioning service.

The Daikin manual also notes that smells from the room, such as cooking, furniture or cigarettes, can be absorbed by the unit and blown back out.

A burning or electrical smell is different. Switch the unit off at the isolator and do not use it until an engineer has checked it.

Noises: normal or a fault?

Some sounds are part of normal operation:

  • a hiss or gurgle as refrigerant flows, especially at start-up and during defrost
  • clicks as the unit expands and contracts with temperature changes
  • a whoosh and hiss from the outdoor unit during a winter defrost

Sounds worth reporting are rattling or buzzing that was not there before, grinding or squealing from a fan, or loud banging or clanking from the outdoor unit. Check nothing is touching the outdoor unit, such as a branch or a loose cover, and if the noise continues, book a repair visit.

Things that look like faults but are normal

  • A delay at start-up or after changing mode. Many units wait a short time before the compressor starts, to protect it. The Daikin manual lists a delayed start after a mode change as normal.
  • Cool air at the start of heat mode. The unit warms up before the indoor fan runs at full speed.
  • Heating stops for a few minutes in cold weather. That is a defrost cycle.
  • Water or steam from the outdoor unit in heat mode, during or after defrost.

When to call an engineer

Do not attempt these yourself

  • Anything involving refrigerant, including topping up, recharging or repairing pipework. By law this must be done by an F-Gas certified engineer.
  • Opening the indoor or outdoor unit beyond removing the filters as the user manual describes.
  • Electrical faults, burning smells, tripping breakers or scorch marks. Switch off at the isolator and leave it off.
  • Repeated fault codes or error lights that come back after a reset.

We are Refcom F-Gas registered (REF1024550) and repair and service all the major brands. Our air conditioning repair service covers diagnosis, leak finding, drain faults and electrical faults.

How to prevent most problems

  1. Clean the filters regularly, following your user manual.
  2. Keep the outdoor unit clear of leaves, plants and stored items.
  3. Use the right mode and a sensible set temperature.
  4. Book a regular service, which covers a deep clean, drain checks and a check that the system is running as it should.
  5. If a problem starts, switch the unit off rather than letting it run with ice or leaks, which can make the damage worse.

If a system is old, keeps failing or was poorly sized in the first place, replacement can be better value. Our air conditioning installation page explains how we size and fit new systems.

What it costs with Vantage

In normal working hours there is no call-out fee. After the first hour, time is charged in half-hour steps, and parts are quoted before we fit them. Evening, weekend and overnight visits are charged at the out-of-hours rates. Every rate is published on our prices page, so you know what you will pay before we arrive.

Frequently asked questions

What is the most common problem with air conditioning?

Dirty filters cause more problems than anything else. They reduce airflow, which leads to poor cooling, icing, water leaks and bad smells. Cleaning them as the manual recommends prevents a lot of call-outs.

Why is my air conditioner running but not cooling?

Check it is in cool mode, the set temperature is below the room temperature, the filters are clean and windows are closed. If it still blows air that is not cold, the system may be low on refrigerant because of a leak, which needs an F-Gas engineer.

What is the three minute rule for air conditioners?

Many air conditioners wait a few minutes before restarting the compressor after they have been switched off or changed mode. This protects the compressor, so a short delay before cooling or heating starts is normal and not a fault.

Why is my air conditioning leaking water inside?

Most indoor leaks are caused by a blocked condensate drain, a drain pipe without enough fall, a failed condensate pump or ice melting off the coil. Clean the filters and switch the unit off. If it keeps leaking, the drain needs clearing by an engineer.

Is it safe to use an air conditioner that smells musty?

A musty smell usually means mould or bacteria on the filters or coil. Clean the filters, and book a service to clean the coil and drain tray properly. A burning smell is different, so switch the unit off and have it checked before using it again.

Air conditioning repairs in Hertfordshire, Bedfordshire and Cambridgeshire

If your system is not cooling, leaking or making a new noise, our F-Gas registered engineers can find the cause and fix it. See our air conditioning repair page or call 01462 506374. The phone is answered 24 hours a day, 7 days a week.

What our customers say

Speak to a local engineer

Vantage Plumbing and Heating covers Hertfordshire, Bedfordshire and the surrounding areas. Call and talk to an engineer, or send us the details and we will come back to you with a price.

Gas Safe registered, number 956889. Emergency line answered 24/7.

Trusted & Accredited Professionals
Checkatrade approved trader
City and Guilds qualified engineers
BPEC certified engineers
Gas Safe registered engineers
Elite CHAS accreditation
London and South East England Prestige Awards 2022 winner
Veriforce CHAS accredited contractor

Rather have an engineer look at it?

Call the office, message us on WhatsApp or ask for a callback. We cover Hertfordshire, Bedfordshire and the surrounding areas.

Why choose Vantage

Rated 4.9 on Google from more than 700 reviews across Google, Checkatrade and Trustatrader. Qualified, accredited engineers, a fixed price before any work begins and a labour guarantee on every job, from an established local company with an office team you can actually reach. No job too small.

The Vantage Plumbing and Heating fleet of five fully stocked liveried vans

Gas Safe registered

Company registration 956889. Every gas engineer carries their own Gas Safe ID card, and you can ask to see it.

Refcom F-Gas certified

REF1024550. Legally required for air conditioning installation and servicing, and we hold it.

CHAS Elite accredited

Veriforce CHAS assessed for health and safety, which is why commercial clients and landlords use us.

City & Guilds and BPEC qualified

Qualified, insured engineers on every job. No subcontracted strangers.

700+ reviews, 4.9 on Google

Across Google, Checkatrade and Trustatrader. Read them before you book.

Labour guarantee on every job

12 months on repairs, installations and everything else. Two years on a full bathroom refit. If anything we did develops a fault, we come back and put it right.

Fixed price before we start

The price is agreed with you before any work begins. No hidden extras on the invoice.

24/7, answered by a person

The emergency line is answered every day of the year by someone who can send an engineer, not a call centre.

Fully stocked vans

Five vans carrying the parts that fail most often, so most jobs are fixed on the first visit.

An office team behind every job

An established local business with multiple engineers and a dedicated office team to keep you informed.

Vaillant myREWARDS and Ideal Max accredited

Accredited installer status means extended manufacturer warranties on the boilers we fit.

Emergency response within the hour

Our average response to an emergency call is under an hour across Hertfordshire, Bedfordshire and Cambridgeshire.

Quick check

Do we cover your postcode?

We work across Hertfordshire, Bedfordshire, Cambridgeshire, Milton Keynes and North, East and West London, including Hitchin, Stevenage, St Albans, Luton and Cambridge. Pop your postcode in and see straight away.

If we cover you, tell us what you need and how soon, and we will ring you back. Prefer to talk now? Call 01462 506 374, answered by a person 24/7.

✓ Yes, we cover you. Fill in the short form below and we will ring you back.
We might not cover your area yet. Send it anyway: fill in the short form below and we will ring you back and tell you honestly whether we can reach you.
Sorry, we do not work in South London. For anything else, ring 01462 506 374.

    Or get your air con price online now →