How to Unblock a Toilet: Step-by-Step Methods That Work
Hertfordshire, Bedfordshire & Cambridgeshire
To unblock a toilet, start with a toilet plunger (the type with a flange that fits into the outlet), using slow, firm pushes to build pressure and shift the blockage. If that does not work, try hot but not boiling water with a squirt of washing-up liquid, then a toilet auger, and if the water still will not go down, or other drains in the house are gurgling or backing up, the blockage is probably further down the drain and needs a plumber or drainage engineer.
In short
- Stop flushing. A blocked toilet can overflow with each flush.
- A flange plunger fixes most toilet blockages. A sink plunger usually will not seal properly.
- Hot (not boiling) water and washing-up liquid can soften paper blockages. Boiling water can crack the pan.
- A toilet auger reaches blockages in the bend that a plunger cannot shift.
- If the bath, shower or sinks drain slowly too, or the outside manhole is full, the blockage is in the drain, not the toilet.
- Avoid chemical drain unblockers and wire coat hangers. They cause more problems than they solve.
First, stop it overflowing
If the water in the pan is high, do not flush again. Each flush adds more water to a pan that cannot empty.
- Take the lid off the cistern and push the flap or flush valve closed if water is still running into the pan.
- Turn off the water to the cistern. Most toilets have a small isolation valve on the pipe feeding the cistern, which you turn a quarter turn with a flat screwdriver.
- Lay old towels around the base of the toilet and put on rubber gloves.
- If the pan is very full, bail some water out into a bucket so you have room to work.
Is it the toilet or the drain?
This decides whether you can fix it yourself. Check these before you start plunging.
- Only the toilet is affected. The blockage is most likely in the toilet pan or the pipe right behind it. The methods below should work.
- Other fittings are slow or gurgling. If the bath, shower or basin drains slowly, or gurgles when you flush, the blockage is probably in the drain that everything shares.
- The outside manhole is full. Lift the cover of the inspection chamber nearest the house, if it is safe to do so. If it is full of water, the blockage is further down the drain. If it is empty, the blockage is between the toilet and that chamber.
A blocked drain is a different job from a blocked toilet. Who is responsible depends on whether the drain serves only your home or is shared with neighbours. Our guide on who is responsible for clearing a blocked drain explains it. If you need help with either, our blocked toilet service covers both.
What you need
- Rubber gloves and old towels
- A bucket
- A toilet plunger with a flange (a soft sleeve that sticks out below the cup)
- A kettle and some washing-up liquid
- A toilet auger (also called a closet auger), if the plunger does not work
- Bin bags for anything you pull out
Method 1: use a toilet plunger
This is the method that works most often.
- Make sure there is enough water in the pan to cover the plunger cup. Add some from a bucket if it is low. The plunger works by pushing water, not air.
- Put the plunger in at an angle so it fills with water rather than trapping air, then fit the flange into the outlet at the bottom of the pan to make a seal.
- Push down slowly the first time, to push out any air.
- Then pump firmly up and down, keeping the seal, about 15 to 20 times. The pull back matters as much as the push.
- Lift the plunger off and see if the water drains away.
- Repeat a few times if the level drops a little but not fully. Stubborn blockages often need several rounds.
- When the water drains, turn the water back on and flush once to check. Keep the plunger ready in case it rises again.
A cup plunger made for sinks has a flat rim that cannot seal in the curved outlet of a toilet, which is why it often seems to do nothing.
Method 2: hot water and washing-up liquid
This helps with blockages of toilet paper and waste, because the soap lubricates and the warmth softens.
- Squirt a good amount of washing-up liquid into the pan and leave it for a few minutes to sink towards the blockage.
- Boil a kettle and let it cool for several minutes so the water is hot but not boiling.
- Pour it into the pan from waist height, in a steady stream, without letting the pan overflow.
- Leave it for 15 to 30 minutes, then try the plunger again.
Never use boiling water. Sudden heat can crack a ceramic pan, and a cracked pan has to be replaced.
Method 3: use a toilet auger
A toilet auger is a short, flexible cable in a rigid tube, with a handle to turn it. It reaches into the bend of the pan to break up or pull out a blockage, such as a wad of wipes or a small object.
- Put the end of the tube into the outlet, with the protective sleeve against the pan so it does not scratch the glaze.
- Turn the handle clockwise while you gently feed the cable in.
- When you feel resistance, keep turning and push gently to break through or hook the blockage.
- Pull the cable back slowly, turning as you go, and put anything you bring out straight into a bin bag.
- Flush once to test.
If the auger reaches its full length without finding anything, or hits something hard it cannot move, stop. The blockage may be a solid object that needs the pan removing, or it may be in the drain.
Method 4: bicarbonate of soda and vinegar
You will see this recommended a lot. The fizzing can help loosen a light blockage, and it will not harm the pan, but it rarely clears a firm blockage on its own. If you try it, pour in a cup of bicarbonate of soda followed by two cups of white vinegar, leave it for 30 minutes, then add hot (not boiling) water and try the plunger.
What not to do
- Do not keep flushing to see if it has cleared. Test with one flush only after the water has drained.
- Do not use boiling water. It can crack the pan.
- Do not use a wire coat hanger. It scratches the glaze, which makes future blockages and staining more likely, and rarely reaches the blockage.
- Avoid chemical drain unblockers in a toilet. They can splash back and burn skin and eyes, they rarely work on a full pan, and they make the job dangerous for whoever has to clear it next. If you have used one, tell the plumber before they start, and never plunge on top of it.
- Never mix different drain chemicals. Some combinations give off harmful fumes.
- If sewage is coming up through another fitting or the outside manhole, stop using water in the house and call a drainage engineer.
What causes toilet blockages?
| Cause | What you might notice | Can you fix it yourself? | What a plumber does |
|---|---|---|---|
| Too much toilet paper at once | Sudden blockage after a single flush | Usually, with a plunger | Clears it with a plunger or auger |
| Wet wipes, including ones labelled flushable | Repeat blockages, slow drainage | Sometimes, with an auger | Clears the pan and checks the drain for a build-up |
| Sanitary products, cotton buds, nappies, kitchen roll | Firm blockage that plunging does not shift | Sometimes | Augers or removes the pan to get it out |
| Toys or objects | Blockage after children have been near the toilet | Rarely | Removes the pan to take the object out |
| Limescale building up in the pan outlet | Toilet blocks more and more often | No | Descales the outlet or replaces the pan |
| Weak flush | Paper left in the pan after flushing | Sometimes | Repairs the flush valve or cistern parts |
| Blocked drain | Other fittings slow or gurgling, manhole full | No | Rods or jets the drain and checks it with a CCTV camera |
Hard water across most of Hertfordshire leaves limescale inside the pan’s outlet over the years, which narrows the passage so paper catches more easily. If your toilet has started blocking regularly, our guide on a toilet that keeps blocking explains the likely reasons.
How to stop it happening again
- Only flush pee, poo and paper. Water companies ask everyone to follow this rule. Everything else, including wet wipes, goes in the bin.
- Keep a bin in the bathroom. People flush things when there is nowhere else to put them.
- Use less paper per flush in a low-flush toilet, or flush twice.
- Get a weak flush repaired. A toilet that does not clear the pan properly will keep blocking.
- Watch what goes into other drains too. Our list of items that should never go down your drain covers the common ones.
When to call a plumber
Call a plumber or drainage engineer if:
- the plunger and auger have not cleared it after several tries
- other fittings are backing up or gurgling
- the outside manhole is full
- you know a solid object has gone down the toilet
- the toilet keeps blocking every few weeks
A plumber will clear the pan with professional tools, and if the problem is in the drain, rod or jet it and use a CCTV camera to find the cause. For drain blockages, see our drain unblocking service.
What it costs with Vantage
In normal working hours there is no call-out fee. After the first hour, time is charged in half-hour steps, and parts are quoted before we fit them. Evening, weekend and overnight visits are charged at the out-of-hours rates. Every rate is published on our prices page, so you know what you will pay before we arrive.
A blockage in the pan is usually a quicker job than one further down the drain, or one that needs the toilet taking off to remove an object.
Frequently asked questions
Does washing-up liquid unblock a toilet?
It can help with soft blockages of paper and waste. Squirt it into the pan, leave it a few minutes, then add hot (not boiling) water and try the plunger. It will not shift wipes, sanitary products or solid objects.
Will a blocked toilet unblock itself?
A blockage of toilet paper can sometimes soften and clear on its own after a few hours. Wipes, sanitary products and objects will not. If the water level drops slowly but the toilet still will not flush properly, it is still partly blocked.
How do you unblock a toilet without a plunger?
Try hot (not boiling) water with washing-up liquid first, then a toilet auger if you have one. If neither works, you need a plunger or a plumber. Avoid coat hangers and chemical unblockers.
Is a blocked toilet an emergency?
If it is your only toilet, or sewage is coming up through other fittings, treat it as urgent. We answer the phone 24 hours a day, 7 days a week, so you can call for help at any time.
Who pays to unblock a shared drain?
If the blockage is in the pipe that serves only your home, it is usually your responsibility. If it is in a drain or sewer shared with neighbours, the water company is usually responsible. Our guide on who is responsible for clearing a blocked drain explains the details.
Rather have an engineer look at it?
Call the office, message us on WhatsApp or ask for a callback. We cover Hertfordshire, Bedfordshire and the surrounding areas.
Help with blocked toilets in Hertfordshire
If you have tried the plunger and the water still will not go down, we can clear it and check the drain behind it. We are based in Stevenage and cover Hertfordshire, Bedfordshire and Cambridgeshire, with the phone answered 24 hours a day. See our blocked toilet service or call 01462 506374.
What our customers say
Speak to a local engineer
Vantage Plumbing and Heating covers Hertfordshire, Bedfordshire and the surrounding areas. Call and talk to an engineer, or send us the details and we will come back to you with a price.
Gas Safe registered, number 956889. Emergency line answered 24/7.
Drain engineers near you
Blocked drain or toilet? We clear it, day or night
We cover Hertfordshire, Bedfordshire and Cambridgeshire. Choose your town:
Not listed? See all the areas we cover or call 01462 506 374